Fat-Iron-QuickStart Guide

Fat Iron - Quick Start Guide

What’s in the Box
• Fat Iron Device
• Charging Base
• AC/DC Adaptor Cord
• Conductive Gel
• User Manual

Before You Start
• Perform a test glide on a small area of skin and wait 24 hours before first use.
• Make sure the treatment area is clean and free of lotions or moisturizers

How to Use
• Remove Fat Iron and components from box.
• Plug the adaptor into the charging base, then into an outlet.
• Place Fat Iron on the base until the charging light is solid (fully charged).
• Spread a thin layer of Conductive Gel on your skin or device surface.
• Press and hold MODE BUTTON to turn on.
• Press MODE to cycle between RF, EMS, or combined modes.
• Increase intensity with INTENSITY MODE BUTTON.
• Glide device on treatment area for at least 15 minutes.
• Turn off by holding MODE BUTTON

Recommended Use
• 3+ times per week for the first 6 weeks.
• After results are achieved, switch to once every 2 weeks for maintenance.
• Each area requires at least 15 minutes per session

Treatment Expectations
• Mild warmth from RF energy is normal.
• Tingling sensation may occur with EMS mode.
• Slight redness may appear and will fade within minutes.
• If treatment feels too hot or irritating, stop and allow skin to cool.

Cleaning & Care
• Turn off device before cleaning.
• Wipe surface with a damp cloth.
• Do not submerge in water.

Safety & Warnings
• Use only as directed with conductive gel.
• Stop use immediately if irritation persist